Scope: explosion-proof type of explosion-proof or dust, applicable to the petroleum, chemical, steel, docks, ships, military, pharmaceutical and other flammable gas mixture containing IIA, IIB, IIC T1-T6 temperature class groups hazardous locations. Features: shell is made of ZL102 aluminum die casting, surface electrostatic spray. Glass shade, stainless steel exposed fasteners. After the protective grille with galvanized surface spray, double corrosion. Ballasts, lighting, interior accessories and lighting one, easy to install. Wireless connection between the lamp body and the outlet cover, installation and maintenance is very convenient. Three installation outlet set to meet different forms of installation requirements. Pipe, and cable wiring. The fixture may be required to install the compensation capacitors, compensated cos ≧ 0.85. Can be configured with different reflection shade depending on the installation, to meet the illumination requirements. Self-developed patented products, counterfeit. Technical parameters: Explosion-proof mark: Ex d IIC T6 Rated voltage: 220VAC 50Hz light source: LED Rated Power: 80 ~ 150W Enclosure protection: IP65 Insulation class: I category: WF2 Line thread: G3 / 4 introduction of cable: φ10 ~ φ14mm use Temperature: -40 ~ + 45 ℃ Total weight: 12.5kg Description: According to the site environment and lighting needs, determine where and how the lighting will be installed in its fixed installation; 220V power contacts from the lamp to press, prepare the appropriate length φ6 ~ 8mm cable. Pressing the lower end of the two lamp cover open button, open the front cover lamps, the prepared cable end of the introduction lamp lumen by introducing compression nut means, in accordance with the wiring seat marked polarity, FireWire connection "L" side, zero line "N" terminal, ground wire to ground terminal, and then tighten the compression nut introduced into the device. Explosion-proof lights aluminum die casting, with articulated screw fastening to quickly open, easy maintenance. Note: When using, has some light surface temperature is a normal phenomenon; Transparency center temperature is higher, not touch. When replacing the lamp, you should use the same type of light bulb; if you change the bulb type or power, shall replace the corresponding ballast. When the distance between the lamp to the ballast over 2 m cable needs to be replaced. Quality assurance: strictly in accordance with ISO9001: 2000 international quality management system standards for quality control to ensure their quality is higher than the national standard, fully meet the design requirements, the product is 3-year warranty (lamp warranty for three years). Within seven years from the date of purchase, under normal use of any failure by the company responsible for maintenance free.